You can not select more than 25 topics Topics must start with a letter or number, can include dashes ('-') and can be up to 35 characters long.
 
 
 
 
 
 
smlng 8acb068dec driver, hd44780: add tests application 5 years ago
..
tests driver, hd44780: add tests application 5 years ago
Makefile driver, hd44780: add tests application 5 years ago
README.md driver, hd44780: add tests application 5 years ago
hd44780_params.h driver, hd44780: add tests application 5 years ago
main.c driver, hd44780: add tests application 5 years ago

README.md

About

This is a test application for the HD44780 LCD driver. This display comes with many Arduino starter kits under the name of LCM1602C, and typically has 16x2 columns and rows.

Details

This test application will initialize the HD44780 driver with the configuration as specified in the default hd44780_params.h file. To connect the display with your board use the following minimal pinout for the LCD (i.e., Arduino here):

  • Pin 1 is connected directly to GND.
  • Pin 2 is connected directly to VCC +5V.
  • Pin 3 is used to set LCD contrast, for max use +5V or a 10k potentiometer.
  • Pin 4 (RS or “register select”) is connected to pin 2 on the Arduino
  • Pin 5 (RW or “read/write”) is connected directly to GND, i.e., unused. Also note: if you connect RW to your board that the LCD is driven by 5V, while many boards internally run at 3.3V - so this could fry the board :/
  • Pin 6 (EN or “enable”) is connected to pin 3 on the Arduino.
  • Pins 7 – 10: Not connected.
  • Pin 11 on the LCD is connected to pin 4 on the Arduino.
  • Pin 12 on the LCD is connected to pin 5 on the Arduino.
  • Pin 13 on the LCD is connected to pin 6 on the Arduino.
  • Pin 14 on the LCD is connected to pin 7 on the Arduino.
  • Pin 15 is connected to one end of a 1k resistor, and its other end to VCC +5V.
  • Pin 16 is connected directly to GND.